CRTC

6845 CRTC

The 6845 CRTC (Cathode Ray Tube Controller) controls how the display is generated. It is written to with VDU 23,0 which also takes account of the current *TV and VDU 23,1 settings. The hardware is directly accessible at &FE00 and &FE01. The 6845 is used in the BBC, Master and System computers. Other display hardware is used on the Atom, Electron, and later computers

Most systems without a hardware 6845 CRTC implement setting the cursor state with registers 10 and 11 via VDU 23;10 and VDU 23;11.

Summary

&FE00 - Select register &FE01 - Write to register 0 - Horizontal total 1 - Horizontal displayed 2 - Horizontal sync position 3 - Sync widths 4 - Vertical total 5 - Vertical total adjust 6 - Vertical displayed 7 - Vertical sync position 8 - Interlace/Display delay/Cursor delay 9 - Scan lines per character 10 - Cursor start line and blink type 11 - Cursor end line

&FE00 - Read from status &FE01 - Read from register 12 - Screen start address 13 - Screen start address 14 - Cursor position 15 - Cursor position 16 - Light pen position 17 - Light pen position 18 - Cursor width (extension) 19 20 21 22 31 - Register 31

((need display diagram here))

&FE00 - Register number

Writing to &FE00 sets the register that will be accessed through the data register. The register number is a 5-bit number 0-31, but registers 18 to 30 are reserved. Register 31 is implemented on some 6845s (but what does it do?).

Some 6845s have a status register that is read at &FE00. This returns the following information:

• bit 7: always zero
• bit 6: set if there is a strobe input to the ~LPEN signal. It is cleared when either R16 or R17 (Light pen position) is read.
• bit 5: set during the vertical blanking period, when the VerticalCount >= VerticalDisplayed.
• other bits: usually zero, but often random

&FE01 - Register data

Using the data register reads or writes to CRTC registers. Registers are normally written to with the VDU 23,0 API.

Write-only registers return &00. Reserved registers (18 to 31) return &00.

Extensions

Extensions to the VDU 23,0 interface, or extended hardware, should probably used register numbers 128 upwards.

Hardware differences

There are several slightly different versions of the 6845. The BBC series require a 6845S varient as the VDU drivers depend on certain functionality:

• R3 Vertical Sync.
• R6 Vertical Displayed any odd/even value, to set to 25 in MODE 3,6,7.
• R8 Character Delay and Cursor Delay timing for MODE 7.

Jgharston 14:47, 24 December 2007 (UTC) Jgharston (talk) 22:43, 15 January 2023 (CET)